Last seen: Apr 19, 2026
The first one allows to send a value for the note-off velocity. The second one allows to use running status, i.e., saving one byte (90 2B 72 2B 00).
MIDI cables connect pins 4 and 5 straight through, i.e., the respective source and sink pins are indeed connected together. On the MIDI OUT port, curr...
This is Running Status. When you see a data byte where you'd expect a status byte, then you have to use the last status byte (here, 0xB0).
With devices that use the MIDI Out circuit suggested by the MIDI Specification, it is possible to steal some power from pin 4. The Alesis Q49 uses a d...
There is an app called Midi Controller that claims to support USB to a Mac. As far as I can see, there is no solution for Windows.
That is not a MIDI file but a Digital Perfomer project file.
A single USB packet can contain multiple MIDI messages. The specification does not say how messages arriving at the same time are handled, but the o...
Doepfer builds such modules, such as "Pocket Electronic" or "Wheel Electronic". Search on doepfer.de.
You did not mention it; did you set the "Computer" switch on the back to "MIDI"? (See p. 16 of the manual; also see all remarks on p. 20.) Did you d...
Implementing USB is not easy. If you do not have experience with this, you should indeed start with USB MIDI 1.0. Note that such libraries always de...
A MIDI Merger in the MFC-to-Axe cable would still allow the data in the other cable (from the AxeFx to the MFC-101) to go through. I am not aware of...
"GM On" changes to General MIDI instruments, i.e., Bank Select messages are ignored."GM2 On" changes to GM2 instruments."GM Off" changes to vendor-spe...
The Oxygen25's USB-B port cannot control other devices; it must be connected to a PC, or to a USB-MIDI Host. To convert MIDI commands to actual soun...
I meant the cable. Apparently, that reputable supplier did not use a cable assembly from a reputable supplier.